Development and Application of Engineering Vehicle Transmission Load Test System
Transmission load was one of the important parameters for engineering vehicle powertrain system, on the basis of calculating drive shaft torque values and ascertaining the measurement point positions, we selected resistance strain guages to design torque sensors and also chose a signal telemetry system, after using a self-made torque calibration bench to statically calibrate torque sensors, we developed a test system for loader drive shaft load. According to the given test program, we performed an actual loader experiment to measure torque at the loader drive shaft measurement points and analyzed the test waveforms. The results of bench calibration and actual loader test showed that the designed torque sensors had a high sensitivity and a good linearity, and the developed test system was correct and effective.
Loader Torque sensor Calibration Torque test Waveform analysis
Li Chao Xu Ru Hai Ge
School of Automobile and Traffic Engineering, Jiangsu University, Zhenjiang, 212013, China HuaiYin Institute of Technology, huaian, 223003,China
国际会议
上海
英文
2019-2023
2011-10-21（万方平台首次上网日期，不代表论文的发表时间）