Application of 3D Solid Modeling in Measurement and Error Evaluation of Spiral Bevel Gear
It is very important to get real factor and ideal factor for the spiral bevel gears error measurement and evaluation. According to its complexity tooth surface shape, the real factor was gotten by CMM which could measure the coordinates of the intersection points in the real gear tooth surface. For the ideal factor, this paper proposed that it was gotten by building the 3d solid modeling in UG based on the gears basic parameters and cutter head parameters. The application of 3d solid modeling in spiral bevel gears error measurement and evaluation was explained by measuring and evaluating the automobile rear axles driven gear. The result shows that this way is very effective and feasible.
3d solid modeling spiral bevel gear error measurement evaluation Introduction (Heading 1)
Zhao Hua Sheng Piao
Department of Mechanical and Electrical Engineering Nan yang Institute of Technology Nan yang 473004, He nan, China
国际会议
重庆
英文
355-359
2011-01-21（万方平台首次上网日期，不代表论文的发表时间）