Annealing Effect and Crystal lization Characteristics of Copper Wire Bonding on Pre-Plated Leadframe
Copper wire bonding on pre-plated leadframe (PPF) is an ever-increasing mode of interconnection in electronic packaging to substitute the gold wire bonding in the volume production in the forthcoming years. Reliability from copper wire bonding should however be well known before putting the process into manufacturing. In this letter, the 4N copper wire with 50 μm diameter bonded on PPF substrate was investigated. It was found for some samples that due to the work hardening effect of the copper, low bonding strength in the heel of the 2nd bond between the copper wire and the PPF surface was noticeable. An anneal process was introduced to recover the microstructural weakness, and wire pull tests revealed that it remarkably enhanced the bond strength of the 2nd joint. Interfacial crystallization characteristics have shown the difference between the lst and the 2nd bonds which were attributed to hot forming and cold forming respectively.
Bing An Lan Ding Techun Wang Tailieh Lu Yiping Wu
School of Materials Science and Engineering, Huazhong University of Science and Technology, Wuhan, 4 ASE Assembly & Test (Shanghai) Limited, 669 Guoshoujing Road, Shanghai, 201203, China
国际会议
2011 International Symposium on Advanced Packaging Materials(2011年先进电子封装材料国际会议APM)
厦门
英文
141-144
2011-10-25（万方平台首次上网日期，不代表论文的发表时间）