Error Estimation for Machining Center Contouring and Its Experimental Verification

摘要：

This paper presents a simulation approach for estimating the trajectory error of a linear interpolation cutter path produced by the numerical control Aco/Dec motion characteristics for a MC. The algorithm is very simple and efficient for simulation calculation. Through comparing the machined profiles of workpiece with the calculated cutter path trajectories, the effectiveness of the proposed approach is sufficiently demonstrated.

关键词： Machining center Contour machining Cutter path Acceleration/deceleration motion Numerical control cutting

作者: Hua Qiu ChaoLin

作者单位: Department of Mechanical Engineering, Kyushu Sangyo University, Fukuoka City, Japan State Key Laboratory of Mechanical Transmission, Chongqing University, Chongqing City, China

会议类型: 国际会议

会议名称: Fourth International Conference on Advanced Design and Manufacturing(第四届先进设计与制造国际会议)

会议地点: 昆明

会议语种:英文

页码: 87-90

在线出版日期: 2011-09-21（万方平台首次上网日期，不代表论文的发表时间）