Optimization of High Performance Engineering Plastics in Thin Wall Part Injection Molding

摘要：

The purpose of this study is to improve the qualities of thin wall part injection molding using polypropylene. The shape of injection molding products is getting more and more complex now, and the requirement for accuracy is also getting higher. The traditional trial and error method and rules of experience cannot be used well at all. This study applied Taguchi method and grey relational analysis to optimize the injection molding process for obtaining multiple quality characteristics of thin wall parts. The experimental results verify the reliability of optimum conditions via confirmation experiment.

关键词： high performance engineering plastics thin wall part injection molding Taguchi method grey relational analysis

作者: Te-Li Su Fu-Chen Kung Yu-Lin Kuo

作者单位: Department of Cosmetic Application and Management,St. Marys Medicine,Nursing and Management College Department of Health Developing and Health Marking,Kainan University, Taoyuan County 338,Taiwan Department of Mechanical Engineering, National Taiwan University of Science and Technology,Taipei 10

会议类型: 国际会议

会议名称: 2011 International Conference on Advanced Material Research(ICAMR 2011)(2011年先进材料研究国际会议)

会议地点: 重庆

会议语种:英文

页码: 58-62

在线出版日期: 2011-01-21（万方平台首次上网日期，不代表论文的发表时间）