Analysis for Diving Regulator of Manufacturing Process
Diving regulator converts the compressed air in a tank into atmosphere air for divers and plays a very important role of SCUBA diving apparatus. The article analyzes its manufacturing process of injection mold in order to enhance the strength after insert molding through the good thermal performance of vapor chamber. The insert molding process is that the metal insert is firstly put into the cavity and then composed an embedded metal-plastic product by injection molding. These results proved that the product strength can be improved significantly with a yield rate up to 100％ through this manufacturing process.
Diving Regulator SCUBA Injection Mold Vapor chamber Insert Molding Process
Jung-Chang Wang Yu-Pin Tsai
Department of Marine Engineering, National Taiwan Ocean University,No.2, Beining Rd., Keelung 202 Taiwan, R.O.C
国际会议
2011 International Conference on Advanced Material Research(ICAMR 2011)(2011年先进材料研究国际会议)
重庆
英文
68-72
2011-01-21（万方平台首次上网日期，不代表论文的发表时间）