Study on Organization and Properties of the new wear-resistant steel

摘要：

By means of wear analysis of the wear-resistant steel used in the process, and adjust the wear-resistant steel composition, by adding alloying elements Cr, Mo and so on, optinlizing heat treatment technique, to get new wear-resistant steel. The HR-150A rock well hardness tester and JB-300B impact tester as well as SHIMADZUAG-I250KV on electronic tensile testing machine were used to test the mechanical properties of materials. In the test of friction and wear performance was done using the high temperature and high-speed friction of wear-testing maching(MMS-1G), and analysis of microscopy and the wear morphology by JSM-5610LV SEM ．The results showed that: The hardness of new wear-resistant steel reaches HRC53, the impact toughness 23J/cm 2 , And at this moment, microstructure of small lath martensite and residual austenite.

作者: LI Ningbo XIE Jingpei WANG Wenyan

作者单位: Materials Science and Engineering School of Henan University of Science and Technology,Luoyang,471003,China

会议类型: 国际会议

会议名称: The 6th International Conference on Physical and Numerical Simulation of Materials Processing(第六届材料与热加工物理模拟及数值模拟国际学术会议 ICPNS 2010)

会议地点: 桂林

会议语种:英文

页码: 1-5

在线出版日期: 2010-11-16（万方平台首次上网日期，不代表论文的发表时间）