Design of Face Gear Drive with Spur Pinion and Experimental Test

摘要：

Based on the technology of face gear shaping, the tooth surface design and geometry were investigated that include tooth generation, limiting inner and outer radii. The computer were applied to simulated tooth contact analysis and transmission ratio of gear drive. A novice method is proposed for face gear generated by use of a general shaper. A face gear with 77 teeth was generated successfully by the shaper. For the purpose to certificate the bearing contact of gear drive, an experimental investigation was also developed in the bevel gear meshing machine. The results show the experimental bearing contact of face gear drive is correspondence to the computerized design, which validated the feasibility of face gear shaping by a general shaper.

作者: Jinglin Tong Yunbo Shen Xiaobo Wang

作者单位: School of Mechanics and Power Engineering Henan Polytechnic University Jiao Zuo 454003 School of Mechatronic Engineering, Xi’an Technological University Xi’an 710032

会议类型: 国际会议

会议名称: 第八届中日机械技术史及机械设计国际会议

会议地点: 河南焦作

会议语种:英文

页码: 1-5

在线出版日期: 2010-10-31（万方平台首次上网日期，不代表论文的发表时间）