Adsorption Filtration Technology Using Reclaimed Iron Sludge Coated Sand Filter Media for Municipal Wastewater Reuse
This paper aims at exploring the feasibility of adsorption filtration technology using reclaimed iron sludge coated sand (RISCS) as filter media for municipal wastewater reuse. The iron sludge as surplus waste solution derived from ferric-carbon micro-electrolysis process. Scanning electron microscope (SEM), Infrared spectroscopy (IR) and X-ray diffraction (XRD) analysis were used to investigate the surface morphology of quartz sand (QS) and RISCS. Batch experiments were performed using QS and RISCS to examine the adsorption isotherms of phosphate and the effect of their dosages on UV254 removal. The results show that RISCS had significantly rougher surfaces, more micropores than QS, and there exist iron oxides (hematite and goethite) on the surface of RISCS. The pHZPC of RISCS was about 7.1, favoring the adsorption of negatively charged particulate onto the RISCS surface. At 20 ℃ , the applicability of the isotherm models for the experimental data follows the order: Freundlich≈Langmuir ＞ Temkin. The Langmuir adsorption capacity for RISCS and QS was 0.0187mg/g and 0.0039mg/g, respectively. RISCS has a much higher affinity for PO4 3-than QS. The results of filtration experiments show that, the removal of COD, PO4 3-and UV254 by RISCS filtration was higher 7.8%, 25.1% and 5.8% than QS filtration, respectively. Effluent quality by RISCS filtration can meet the requirements of <Municipal wastewater reuse—— miscellaneous water quality> (GB/T 18920-2002) in China.
Lǚ Jianbo Sun Liping Li Yuyou Jia Renyong Yi Xuesong
Department of Environmental and Municipal Engineering, Tianjin Institute of Urban Construction, Tian Department of Environmental and Municipal Engineering, Tianjin Institute of Urban Construction, Tian
国际会议
成都
英文
1-4
2010-06-18（万方平台首次上网日期，不代表论文的发表时间）