Investigations on Friction Resistance of Forced Circulation in a Circular Tube under Inclination and Rolling Conditions
The friction resistance under marine conditions is very important to a marine reactor system in the ocean. The traditional empirical or semi-empirical relationships were used in thermo-hydraulic system programmes at the present time, while the applicability of these relationships under ocean conditions was not validated adequately. Experiments have been conducted to study the friction resistance of forced circulation when the test tube was at inclined attitude and rolling model. The experimental setup consists of stainless steel cylinder tube as test section with 10mm inside diameter and 1200mm length, is subjected to a constant wall heat flux boundary condition. The investigation covers Reynolds number range from 1.0e+4 to 1.2e+5, and the test section angles of inclination including 10o,20oand 30o,amplitudes of rolling angle including 10o,15oand 20owith the rolling periods of 10s,15s and 20s. Pressure drop was measured to calculate the coefficient of friction resistance. CFD method was used to simulate the flow characteristics under inclination and rolling conditions, the results were compared with experimental data. The investigations showed that the influence of inclination and rolling to friction coefficient is not obvious.
Du Sijia Zhang Hong
Department of Engineering Physics, Tsinghua University & National Key Laboratory of Science and Tech National Key Laboratory of Science and Technology on Reactor System Design Technology of Nuclear Pow
国际会议
18th International Conference on Nuclear Engineering(第18届国际核能工程大会 ICONE 18)
西安
英文
1-6
2010-05-17（万方平台首次上网日期，不代表论文的发表时间）