会议专题

FABRICATION METHODS DEVELOPMENT FOR THE KOREA TBM FIRST WALL IN THE ITER

The Republic of Korea has proposed and designed a helium cooled molten lithium (HCML) test blanket module (TBM) to be tested in the ITER. Ferritic Martensitic Steel (FMS) and beryllium are designed to be used as structural material and armor for the TBM first wall (FW) in this design, respectively. In order to develop the fabrication method for the TBM FW, the joining methods of FMS to FMS and Be to FMS have been developed with hot istotatic pressing (HIP). For joining FMS to FMS, mock-ups were fabricated with an HIP (1050 o C, 100 MPa, 2 hours). For joining Be to FMS, two mock-ups were fabricated with the same method (580 o C, 100 MPa, 2 hours) using different interlayers. Then, in order to evaluate the integrity of the fabricated mock-ups, they were tested at the high heat flux (HHF) test facilities, KoHLTs (Korea Heat Load Test) under 1.0 MW/m 2 and 0.5 MW/m 2 heat fluxes of up to 1000 cycles.

Dong Won LEE Young Dug Bae Suk Kwon Kim Jae Sung Yoon Bong Guen Hong Yang Il Jung Jung Yong Park Byung Kwon Choi Yong Hwan Jeong

Korea Atomic Energy Research Institute Daejeon, Republilc of Korea

国际会议

18th International Conference on Nuclear Engineering(第18届国际核能工程大会 ICONE 18)

西安

英文

1-5

2010-05-17(万方平台首次上网日期,不代表论文的发表时间)