The research of preparation and characterization of PET/CB bottle
The PET/CB composite materials were prepared in this study via following steps: First, in-situ polymerization of PET and modified carbon black (CB) were performed; and then followed solid-phase viscosity-increasing and injection molding process; finally, the high endothermic PET/CB bottle was completed after the last biaxial-elongation blow molding procedure. The chemical structure and properties of this PET/CB bottle were analyzed by infrared absorption measurement, differential scanning calorimeter (DSC), and Haze and Luminous transmittance meter. The infrared absorption measurement results showed that a higher infrared absorption rate of PET/CB bottle was obtained because of the addition of high endothermic carbon black. Compared to pure PET bottle, PET/CB bottle possessed higher crystallization temperature and faster crystallization rate. Haze and Luminous transmittance meter experiments also manifested that PET/CB bottle had good transparency.
GU Xiaohua LI Chuncheng NIU Shuqing LI Shiwei
CAS Key Laboratory of Engineering Plastics, Joint Laboratory of Polymer Science and Materials, Cente CAS Key Laboratory of Engineering Plastics, Joint Laboratory of Polymer Science and Materials, Cente Qiqihar University, Qiqihar 161006, P.R.China
国际会议
2009 International Conference on Advanced Fibers and Polymer Materials(2009年先进纤维与聚合物材料国际学术会议)
上海
英文
255-257
2009-10-21（万方平台首次上网日期，不代表论文的发表时间）