Technology of gear shaping of face gear and experimental studies
Face gear Is the major parts of helicopter transmissions for split torque equipment The process generation of face gear is critical factors to prevent the face gear drive to be applied. A novice method is proposed for face gear generated by use of a general shaper. Face gear design and geometry were investigated that include tooth generation, limiting inner and outer radii, tooth contact analysis of gear drive. A face gear with 89 teeth was generated successfully by the shaper. In order to demonstrate the bearing contact of face gear drive, an experimental investigation was also developed in the bevel gear meshing machine. The results show the bearing contact of face gear drive is correspondence to the computerized design, which validated the feasibility of face gear shaping by a general shaper.
face gear drive bearing contact shaper undercutting and pointing
Yunbo Shen Jinglin Tong
School of Mechatronic Engineering, Xian Technological University Xian China School of Mechanics and Power Engineering Henan Polytechnic University Jiao Zuo China
国际会议
2010 International Conference on Digital Manufacturing and Automation(2010 数字制造与自动化国际会议 ICDMA 2010)
长沙
英文
609-612
2010-12-18（万方平台首次上网日期，不代表论文的发表时间）