DEVISING AN ENERGY SAVING MEMBRANE SEPARATION PROCESS FOR THE EFFLUENT TREATMENT FROM ALKALINE PEROXIDE MECHANICAL PULPING PLANTS
According to our previous study, it is believed that ultra-filtration with polyethersulfone (PES) flat-sheet membrane is suitable for the concentration process of alkaline peroxide mechanical pulping (APMP) plant乫s effluent. So we scaled up the concentrating experiment to a pilot-scale. Specifically, the cross-flow velocity and volume reduction factor were optimized again for a higher flux and a lower system energy consumption. A mathematical model was established to obtain the optimal parameters. An estimation of energy and water saving effect was also developed. The optimal ultrafiltration conditions obtained were: molecular weight cut-off at 10,000 Dalton, trans-membrane pressure at 3 bar, feed temperature at 50亷, cross-flow velocity at 2 m/s, and volume reduction factor at 0.9. The average permeate flux under these conditions was 43.21 l/(m2.h). The total solids content was increased from 25.47 g/l in the feed to 128.36 g/l in the concentrate. The permeate had low total solids content of 11.03 g/l, Chemical Oxygen Demand of 9180 mg/l, and Biochemical Oxygen Demand of 5870 mg/l. Such qualities would allow the permeate to be reused in the APMP process after lightly biochemical treatment. With this new concentration process, about 6201.7 kWh energy can be saved and 22.5 m3 effluent discharge can be reduced for each ton of pulp produced.
Alkaline peroxide mechanical pulping effluent polyethersulfone membrane concentrating energy saving discharge reduction
Zhang Yong Cao Chunyu Feng Wenying Hou Qingxi Xu Ming Su Zhenhua Lin Qiaoyuan Lv Weijun
China National Pulp and Paper Research Institute,Beijing, 100020, China College of Material Science & Chemical Engineering,Tianjin University of Science & Technology, Tianj
国际会议
广州
英文
1087-1090
2010-11-08（万方平台首次上网日期，不代表论文的发表时间）