A Design Method for Automatic Calibration System based on Dynamic Loading and Dynamic Scheduling

摘要：

For efficient calibration of electronic instruments, we need to improve the general accepted approaches by introducing an automatic system with a properly defined calibration procedure, thus freeing people from tedious, time consuming calibration process. This paper present a design method for automatic calibration system based on dynamic loading testing subroutines and dynamic scheduling hardware. Dynamic loading technology is seriously depending on uniform interface definition, and which can make the system more open and easier to maintenance and update. Dynamic scheduling technology can improve the calibration efficiency greatly in the case of more than one device under test (DUTs). In the last of paper, a system developed for some type of RF instruments is shown as a development example.

关键词： automatic calibration system metrology dynamic loading dynamic scheduling.

作者: Fang Hong Bian Xin Zhou Xin Liu Ke Zhao Haining

作者单位: Division of Electronics and Information Technology,National Institute of Metrology,Beijing 100013,China

会议类型: 国际会议

会议名称: 2011 10th International Conference on Electronic Measurement & Instruments(第十届电子测量与仪器国际会议 ICEMI2011)

会议地点: 成都

会议语种:英文

页码: 515-519

在线出版日期: 2011-08-16（万方平台首次上网日期，不代表论文的发表时间）