Fault Samples Simulation Based on Monte Carlo Method in Testability Virtual Test
Fault injection is a major method applied in the testability verification, so the fault samples selection is a key factor to the confidence level of evaluation conclusion.There are some deficiencies in the exiting fault samples selection methods because of not considering the fault effect and fault rate varying. Aiming at the shortage of the existing fault samples selection method, a fault samples generation method based on Monte Carlo method is proposed respectively to the corrective maintenance and regular maintenance under the background of testability virtual test in this paper. The Multisim10 is utilized to build the fault models and simulate the process of fault injection.The results show that this method can simulate the fault samples effectively that can be injected in the testability virtual test.
Testability verification Virtual test Fault samples Monte Carlo method
Chenxu Zhao Guanjun Liu Jing Qiu Yong Zhang
Laboratory of Science and Technology on Integrated Logistics Support National niversity of Defense T Laboratory of Science and Technology on ntegrated Logistics Support National University of Defense T Laboratory of Science and Technology on Integrated Logistics Support National University of Defense
国际会议
贵阳
英文
358-362
2011-06-12（万方平台首次上网日期，不代表论文的发表时间）