Four Methods for Roundness Evaluation

摘要：

Whether roundness error can be evaluated accurately and efficiently or not will directly influence the mechanical products performance and life. For this reason, this paper introduces simple and efficient algorithms to evaluate the roundness error from the measured points using four internationally defined methods: Least Squares Circle (LSC), Minimum Circumscribed Circle (MCC), Maximum Inscribed Circle (MIC) and Minimum Zone Circles (MZC). A software has been developed using Matlab to apply these algorithms on the test data.

关键词： Roundness error Optimization Minimum zone circle Minimum circumscribed circle Maximum inscribed circle

作者: Wentao Sui Dan Zhang

作者单位: School of Mechanical Engineering Shandong University of Technology Zibo China School of Electrical & Electronic Engineering Shandong University of Technology Zibo China

会议类型: 国际会议

会议名称: 2010 4th International Conference on Intelligent Information Techonlogy Application(第四届智能信息技术应用国际学术研讨会 IITA 2010)

会议地点: 秦皇岛

会议语种:英文

页码: 330-332

在线出版日期: 2010-11-05（万方平台首次上网日期，不代表论文的发表时间）