Research of Tool Swinging Method Processing Aspheric Optical Parts

摘要：

To solve the tricky problem of machining aspheric optical parts, a new aspheric surface processing method using cutting tool swinging method is proposed. With Spherical tool, in two-dimensional plane through tools rotation and swinging for machining to achieve on the workpiece, while enhancing device through each point of the tool feed direction is consistent with the normal direction points to ensure the processing of symmetry.Theoretical explanations are given for the new method, as well as theoretical verification using paraboloid as an example. Machine tool kinematics analysis is made under the given surface roughness. And in under the surface roughness which assigns to the engine bed carries on the movement analysis. The advantage of this new technology is confirmed.

关键词： aspheric optical parts cutting tool paraboloid roughness

作者: WANG Hong-chen CUI Chi-yu

作者单位: Engineering Training Center ChangChun Institute of Technology Changchun,CHINA Changchun Mann + Hummel FAWAY Filter Co.,Ltd. Changchun,CHINA

会议类型: 国际会议

会议名称: 2010 International Conference on Computer,Mechatronics,Control and Electronic Engineering(2010计算机、机电、控制与电子工程国际会议 CMCE 2010)

会议地点: 长春

会议语种:英文

页码: 498-501

在线出版日期: 2010-08-24（万方平台首次上网日期，不代表论文的发表时间）