Statistical Analysis of Cutting Forces in Turning Inconel 718 with Coated Carbide Tools
The experimental study presented in this paper aims to investigate the effects of cutting parameters on cutting forces, and search the optimal cutting parameters for the minimum cutting forces during turning Inconel 718 under dry cutting conditions. Based on Taguchi method, a L25 (53) array was designed to conduct the turning experiments. The experimental results indicate that the best condition for the minimum cutting force components is the combination of 45m/min cutting speed, 0.08mm/r feed rate, and 0.2mm depth of cut. The effects of the cutting parameters on cutting forces are investigated while employing the analysis of variance (ANOVA). Finally, the quadratic regression equations for cutting forces were formulated, which can well describe the relationship between cutting parameters and cutting forces.
Cutting parameters Cutting forces Inconel 718 ANOVA
Xiaoli Zhu Song Zhang Tongcao Ding Yuanwei Wang
Key Laboratory of High Efficiency and Clean Mechanical Manufacture of MOE,School of Mechanical Engineering, Shandong University, Jinan 250061, China
国际会议
广州
英文
96-101
2010-11-05（万方平台首次上网日期，不代表论文的发表时间）