Study on Contact Friction between Polishing Disk and Workpiece during Face Polishing with ANSYS

摘要：

Since almost large die surfaces are free-form surfaces, currently, these are almost manually implemented. In order to overcome this barrier, floating polishing is a feasible polishing technology. The contact friction between polishing disk and workpiece is a key problem of floating polishing technology. This paper tries to study the contact friction between polishing disk and workpiece with ANSYS analysis software. At first, the paper focuses on the contact friction between polishing disk and plane workpiece by ANSYS analysis software, then focuses on the contact friction between polishing disk and cylinder and sphere workpiece with the software. The analysis results show the hypothesis of full friction condition is feasible. The research results will be used for developing the floating polishing.

关键词： Face polishing Contact friction Polishing disk ANSYS

作者: Xiaocun Xu Yangang He Xiangkai Xin Bing Lin

作者单位: Harbin University of Science & Technology, Harbin 150080, China

会议类型: 国际会议

会议名称: International Conference on Surface Finishing Technology & Surface Engineering(2010年中国国际光整加工技术学术会议 ICSFT 2010)

会议地点: 广州

会议语种:英文

页码: 139-142

在线出版日期: 2010-11-05（万方平台首次上网日期，不代表论文的发表时间）