Surface Roughness and Cutting Force of Inconel 718 Machined by Different Cutting Tools

摘要：

Given the stringent operating conditions to which super alloys are subjected to in aerospace, nuclear power and gas turbine industries, their efficient machining and generation of machined surfaces with high integrity assumes a lot of importance. Therefore, this paper presents an experimental investigation on the surface roughness and cutting force of Inconel 718 machined with several different kinds of cutting tools. Both single-factor and orthogonal experiments were carried out with cemented carbide, cermet and CBN tools. The effects of cutting tools and cutting parameters on the surface roughness and cutting force are investigated and the optimal cutting conditions are recommended.

关键词： Surface roughness Cutting force Inconel 718

作者: G.S.Geng J.H.Xu Y.C.Fu B.Y

作者单位: College of Engineering, Nanjing Agricultural University, Nanjing 210031, China,College of Mechanical College of Mechanical and Electrical Engineering, Nanjing University of Aeronautics and Astronautics

会议类型: 国际会议

会议名称: International Conference on Surface Finishing Technology & Surface Engineering(2010年中国国际光整加工技术学术会议 ICSFT 2010)

会议地点: 广州

会议语种:英文

页码: 232-237

在线出版日期: 2010-11-05（万方平台首次上网日期，不代表论文的发表时间）