Correction and Data Processing for Tooth Surface Deviation of Hypoid Gear

摘要：

The correction and the data processing for tooth surface deviation of hypoid gear are a key link to the realization of the digitized closed loop manufacture. Based on one-dimensional probe, the method of error compensation for hypoid gears is studied. By means of the principle of the proportional correction of spiral bevel gears, the theory and the method of the automatic compensation and feedback correction to machine tool settings are investigated according to the measuring data. Without the human intervention, the correction of machine tool settings can be automatically completed. And 1 to 3 trial cuts, the tooth surface deviations can meet the design requirement Finally, the correction of machine tool settings and the contact pattern test of tooth surfaces have been carried out All these verify that the approaches of the correction and the data processing are feasible and accurate.

关键词： one-dimensional probe hypoid gears measurement of tooth surface deviation automatic correction digitized closed loop manufacture

作者: Tianxing Li Tianxing Li Xiaozhong Deng Bingyang Wei

作者单位: School of Mechatronics Northwestern Polytechnical University XTan China School of Mechatronics Engineering Henan University of Science & Technology Luoyang China

会议类型: 国际会议

会议名称: The 2nd IEEE International Conference on Advanced Computer Control(第二届先进计算机控制国际会议 ICACC 2010)

会议地点: 沈阳

会议语种:英文

页码: 262-266

在线出版日期: 2010-03-27（万方平台首次上网日期，不代表论文的发表时间）