An Experimental Study on Rough Ball-end milling of T10A Steel

摘要：

The milling experiments of the annealed T10A steel were carried out in the various cutting conditions using the coated cemented carbide tool. The cutting parameters were designed by the multi-factor orthogonal experiment method, and the effects of cutting speed, feed, axial depth of cut and radial depth of cut on the cutting force and tool wear were investigated. The tool wear mechanisms were also discussed. Adhesion, abrasion, diffusion and oxidation were the main tool wear mechanisms. According to these investigations, the optimizing cutting parameter was recommended.

关键词： Cutting force Tool wear Ball-end milling Cutting parameters

作者: X.Q. Zhuang C.Z. Huang Z.Y. Liu B. Zou H.L. Liu H.T. Zhu

作者单位: Centre for Advanced Jet Engineering Technologies (CaJET), School of Mechanical Engineering,Shandong University, Jinan 250061, ChinaKey Laboratory of High-efficiency and Clean Mechanical Manufacture (Shandong University),Ministry of Education, China

会议类型: 国际会议

会议名称: The 4th International Conference on High Speed Machining(第四届高速加工国际会议 ICHSM2010)

会议地点: 武汉

会议语种:英文

页码: 78-83

在线出版日期: 2011-05-28（万方平台首次上网日期，不代表论文的发表时间）