会议专题

Comparative Study on 2A70 Aluminum Alloy High-speed Milling Cutting Force Model

The mechanical properties of flat end mill is analyzed the high-speed milling, the linear model for milling force is established. And the 2A70 aluminum alloy four-factor four-level orthogonal milling tests are carried out, the nonlinear model of milling is set up by using regression analysis method. The comparative analysis is made between the linear model and nonlinear model, whose results show that the two models have good agreement on the value and trend of change, which is the basis of the follow-up tool path optimization, fault diagnosis and so on.

High speed machining Cutting force Linear model Noninear model

X.H. Wang M.J. Feng C. Zhao

Collage of Mechanical Engineering, Heilongjiang Institute of Science and Technology, Harbin,150027 T Modern Manufacturing Center, Heilongjiang Institute of Science and Technology, Harbin, China,150027

国际会议

The 4th International Conference on High Speed Machining(第四届高速加工国际会议 ICHSM2010)

武汉

英文

254-257

2011-05-28(万方平台首次上网日期,不代表论文的发表时间)