Finite element method modeling approaches in grinding

摘要：

In the present paper, a three-dimensional finite element model was used for simulating the grinding force at different cutting conditions. The effects of the wheel speed, feed and grinding depth on the grinding force per unit width were analyzed in detail. The results show that both the normal force and tangential force increase linearly with the increasing of feed and grinding depth, however, with the increasing of wheel speed, the grinding force decreases gradually. The predicted normal and tangential grinding forces were compared with those experimentally obtained and the results show reasonable agreement quantitatively.

关键词： Finite element method Grinding Grinding force.

作者: H.L. Zhang H. Guo

作者单位: School of Mechanical Engineering, Shenyang Ligong University, Shenyang 110159, China

会议类型: 国际会议

会议名称: The 4th International Conference on High Speed Machining(第四届高速加工国际会议 ICHSM2010)

会议地点: 武汉

会议语种:英文

页码: 368-371

在线出版日期: 2011-05-28（万方平台首次上网日期，不代表论文的发表时间）