Rapid Selection of Milling Tools Based on the Initial Wear

摘要：

In this paper, tool life, tool wear criteria, initial wear and cutting length at initial wear are picked out from 295 milling tool wear curves to calculate initial wear rate K0, final wear rate K1 and the ratio K between the two. By statistic analysis of K0, K1 and K, a statistical regularity between K0 and K1 is found, which indicates that the faster the initial wear, the shorter the tool life would be. Based on the statistical regularity, a milling tool rapid selection method is proposed, and an experiment on selecting the best tools for machining TC4 is carried out to verify the method. The results show that the method can reduce the consumption of material and time significantly, which confirm the efficiency of the method.

关键词： Statistical regularity Initial wear Tool life Rapid selection of milling tools

作者: H. Zhang W.Y. Chen

作者单位: P.O.Box 705, Beihang University,Beijing, China P.O.Box 705, Beihang University, Beijing, China

会议类型: 国际会议

会议名称: The 4th International Conference on High Speed Machining(第四届高速加工国际会议 ICHSM2010)

会议地点: 武汉

会议语种:英文

页码: 416-422

在线出版日期: 2011-05-28（万方平台首次上网日期，不代表论文的发表时间）