The Impeller five-axis NC machining simulation based on UG NX 7.5

摘要：

To improve the processing efficiency and Surface qualityof impeller. Impeller processing difficulties as a major object of study were researched by this paper. Using UG7.5 impeller processing module, Based on the impeller feature division idea and to optimize the impeller machining path.Finally, Through it carried out the tool path generation and simulation and verify the feasibility of processing. To effectively enhance programming efficiency and processing quality.

关键词： NC Simulation Path Optimization Impeller

作者: J.C. Huang X.L. Liu D.K. Jia W.D. Li K.Guo

作者单位: The Key Lab of Advanced Manufacturing Tech. & Cutting Tools, Harbin Univ. of Sci. and Tech,Harbin, 150080, PR China

会议类型: 国际会议

会议名称: The 4th International Conference on High Speed Machining(第四届高速加工国际会议 ICHSM2010)

会议地点: 武汉

会议语种:英文

页码: 689-692

在线出版日期: 2011-05-28（万方平台首次上网日期，不代表论文的发表时间）