Study of Modeling and Kinematic Simulation for Cam-linkage Reducer Based on Pro/E
In this paper, firstly, a new type cam-linkage combined mechanism was briefly introduced. Secondly,the requirements of major components of cam-linkage reducer were discussed. And then, 3D parametrized design and virtual assembly for cam and other parts was realized by using Pro/E, and the interference of the whole reducer was detected, optimized design of componets was implemented. In the end, kniematic simulation of reducer model was analyzed. It is not only helpful to improve the efficiency of production design, shorten the design cycle and fulfill optimized and series design, but also useful to provide accurate models for FEM analysis.
cam-linkage reducer modeling virtual assembly Interference detection kinematic simulation
Baomin Wang Yingkang Zou Peng Li
School of Mechanical Engineering, Shaanxi University of echnology, Hanzhong, 723003, China School of Mechanical Engineering, Shaanxi University of Technology, Hanzhong, 723003, China
国际会议
成都
英文
100-102
2010-12-03（万方平台首次上网日期，不代表论文的发表时间）