SIMULATION STUDY ON ROLLING FORCE OF FORMING LIGHT AREA REDUCTION SHAFTS BY CROSS WEDGE ROLLING

摘要：

The theoretical calculation of rolling force was presented in this paper. With the software ANSYS/LS-DYNA, the change feature of rolling force for the light area reduction shaft was analyzed through a comparison with that of the conventional area reduction rolled piece. It is shown that rolling force keeps increasing in the stretching zone, and attains the maximum value at the end of the stretching zone. And the rolling force can be significantly reduced by making void treatment on the dies. Then the effects of process parameters on rolling force were also obtained and the simulation results indicate that rolling force reduces with the increase of forming angle, but increases with the increase of stretching angle and stretching length.

关键词： light area reduction cross wedge rolling finite element method (FEM) rolling force

作者: LIU Wen Ke ZHANG Kang Sheng HU Zheng Huan

作者单位: School of Mechanical Engineering,University of Science and Technology Beijing, Beijing 100083, China

会议类型: 国际会议

会议名称: The International Conference on Advanced Technology of Design and Manufacture 2010(2010先进设计与制造技术国际研讨会)

会议地点: 北京

会议语种:英文

页码: 334-337

在线出版日期: 2010-11-23（万方平台首次上网日期，不代表论文的发表时间）