A DATA RECOVERY METHOD FOR HIGH-SPEED SERIAL COMMUNICATION BASED ON FPGA

摘要：

Nowadays, serial communication is used in many high-speed communication situations instead of parallel communication. In high-speed serial communications, data recovery is an important and difficult part, which directly determines the success or failure of communication. This paper presents a FPGA-based data recovery method for high-speed serial signal. First, each bit of serial signal is over-sampled by four times and synchronized, then the transition edges of signal is detected, and finally we select the optimal sampling points to recover out the data that is synchronized with the standard sampling clock. Experimental results show that this method ran well under the data transmission rate of 50Mbps.

关键词： Data recovery over-sampling FPGA serial communication

作者: Li Pang Houde Liu Baohua Li Bin Liang

作者单位: Division of Control and Mechatronics Engineering,Harbin Institute of Technology Shenzhen Graduate Sc Division of Control and Mechatronics Engineering, Harbin Institute of Technology Shenzhen Graduate S

会议类型: 国际会议

会议名称: 2010 2nd IEEE International Conference on Network Infrasturcture & Digital Content(2010年第二届IEEE网络基础设施与数字内容国际会议 IC-NIDC 2010)

会议地点: 北京

会议语种:英文

页码: 664-667

在线出版日期: 2010-09-24（万方平台首次上网日期，不代表论文的发表时间）