Algorithm Based on 5-axis NC Flank Milling of Arbitrary Surfaces

摘要：

In order to improve quality and efficiency of the overall five-axis milling for arbitrary surface impellers. In rough milling, the arbitrary surface was replaced by fitted ruled surface, the flank milling was a good method to replace the point milling. In semi-finish milling, the primal surface was replaced by piecewise ruled surfaces, using step flank milling to gain the satisfaction in models nicety and machining efficiency. Then , algorithm of the paper is proved to be viable by Model building, NC programming and machining

关键词： flank milling algorithm ruled surface arbitrary surface

作者: Hongbo Wang Guocheng Sheng

作者单位: Research Center of Electromechanical Technology, Zhejiang Normal University, Jinhua, China

会议类型: 国际会议

会议名称: 2010 International Conference on Advanced Mechanical Engineering(2010年先进机械工程国际学术会议 AME 2010)

会议地点: 洛阳

会议语种:英文

页码: 265-268

在线出版日期: 2010-09-04（万方平台首次上网日期，不代表论文的发表时间）