Semi-solid near-net shape rheocasting of heat treatable wrought aluminum alloys
Flexibility of the CSIR-RCS,induction stirring with simultaneous air cooling process,in combination with high pressure die casting is successfully demonstrated by semi-solid rheocasting of plates performed on commercial 2024,6082 and 7075 wrought aluminum alloys.Tensile properties were measured for the above mentioned rheocast wrought aluminum alloys in the T6 condition.The results showed that tensile properties were close to or even in some cases exceeded the minimum specifications.The yield strength and elongation of rheocast 2024-T6 exceeded the minimum requirements of the wrought alloy in the T6 condition but the ultimate tensile strength achieved only 90％ of the specification because the Mg content of the starting alloy was below the commercial alloy specification.The strengths of rheocast 6082-T6 exceeded all of the wrought alloy T6 strength targets but the elongation only managed 36％ of the required minimum due to porosity,caused by incipient melting during solution heat treatment,and the presence of fine intermetallic needles in the eutectic.The yield strength of rheocast 7075 exceeded the required one and the ultimate tensile strength also managed 97％ of the specification;while the elongation only reached 46％ of the minimum requirement also due to incipient melting porosity caused during the solution heat treatment process.
high pressure die casting (HPDC) aluminum alloys as-cast condition T6 treatment incipient melting
U.A.CURLE
Materials Science and Manufacturing, Council for Scientific and Industrial Research, Pretoria, South Africa
国际会议
北京
英文
1719-1724
2010-09-16（万方平台首次上网日期，不代表论文的发表时间）