Mathematical modeling of EDM hole drilling using response surface methodology
This paper reports an experimental investigation of EDM drilling of Φ2 mm holes on Inconel 718 using brass electrode. The effect of process parameters (discharge current, pulse on and off times, and capacitance) on process outputs (material removal rate and electrode wear rate) was determined based on minimum number of experiments. The mathematical modeling of process has been done using response surface methodology. The results show that the developed model can achieve reliable prediction of experimental results within acceptable accuracy.
Electrical discharge machining IN718 response surface methodology
A. Tolga Bozdana Oguzhan Yilmaz M. Ali Okka I. Huseyin Filiz
Department of Mechanical Engineering, The University of Gaziantep, 27310, Gaziantep, Turkey
国际会议
宁波
英文
90-94
2010-01-11（万方平台首次上网日期，不代表论文的发表时间）