Research on cutting remanufacture deposited materials in the impactive condition
Orthogonal experimental were carried for cutting remanufacture deposited Materials in the impactive condition. By the experiments analysis, it can be known that the cutting capability of tools were determind by toughness of tools when the hardness of deposited materials is low. And the hardness of tools becomes the main roles for improving cutting capability when the hardness of deposited materials arrives to HRC56. At the same time, orthogonal design-direct analysis shows that the impact resistant capability of tools does not always means improvement in cutting capability. The comprehensive balance between strength of tools and impacts in the process is favorable method to improve cutting capability of tools.
impactive cutting orthogonal experiment deposited materials Remanufacture
Z.Y.Wu X.L.Tian S.Zhang X.Huang S.H.Wang
National Key Laboratory for Equipment Remanufacturing, Academy of Armored Force Engineering , China, Department of Scientific Research, Academy of Armored Force Engineering, China, 100072
国际会议
宁波
英文
165-170
2010-01-11（万方平台首次上网日期，不代表论文的发表时间）