An Open NC System Based on Wireless Communication Technology
Traditional NC system supports the measurement of equipment but this system is based on the wired network. This system has advantages and disadvantages at the same time. The wired NC System has accurate transfer rate but has more additional expense and not supporting the mobility. For this reason, we proposed a new open NC system model based on wireless communication technology. In this paper, which consists of two parts: a part of the mobile handheld controller, that is NC PDA; the other part is installed on the machine, to completion traditional PLC and motion control functions, known as embedded machine tool controller. Between the two parts achieve interconnection through the Wi-Fi (IEEE802.11) wireless communications interface.
Open NC system model NC PDA Embedded machine controller Wi-Fi (IEEE802.11)
Zhenyu Yang Dong Li Faying Liu
School of Mechanical Engineering, Shandong University of Technology, Zibo, China School of Computer Science and Technology, Shandong University of Technology, Zibo, China School of Electrical and Electronic Engineering, Shandong University of Technology, Zibo, China
国际会议
2009 International Workshop on Information Security and Application(2009 信息安全与应用国际研讨会)
青岛
英文
360-362
2009-11-21（万方平台首次上网日期，不代表论文的发表时间）