Inverse Design of Cam Contour by NURBS Spline

摘要：

In this paper, according to the requirements of some cam component in rotary press, cubic NURBS spline is used to generate the contour of cam after calculating every control point on the basis of movement requirement of driven part. And software ADAMS is used to verify the calculation result. Results show this method is an effective way for manufacturers of rotary press to generate cam contour, which can improve the performance of cam mechanism and save much time.

关键词： Cam NURBS ADAMS Rotary Press

作者: A.F.Yuan

作者单位: Nanjing University of Information Science and Technology,School of Information and Control,No.219 Ningliu Rd. Nanjing,210016,China

会议类型: 国际会议

会议名称: The 3rd Conference of Cross-Strait Engineering Education and Ceeusro & 1st International Conference on Engineering Technologies and Ceeusro(ICETC2009)(第三届工程技术与产学研研讨会暨第一届国际功能制造技术学术会议)

会议地点: 常州

会议语种:英文

页码: 230-234

在线出版日期: 2009-11-19（万方平台首次上网日期，不代表论文的发表时间）