A Simultaneous Smooth Processes Using Burnishing and Elecrofinishing on the Plane Surface
For the purpose of elevating the efficiency of the finish effect to reach the fast improvement of the surface roughness of the plane surface, so as to reduce the residual stress on the surface efficiently. This study discusses the plane surface after traditional grinding machining, of which the plane surface used a new design of finish-tool includes a nonconductive burnishing-tool and a negative electrode to execute the simultaneous processes of burnishing and electrofinishing. In the experiment, the use of the small thickness of the negative electrode is advantageous to the finish effect. High rotational speed of the finish-tool produces better polishing. Higher current rating with quicker workpiece feed rate effectively reaches the fast improvement of the surface roughness of the workpiece. The finishing effect is better with longer off-time because discharge of the electrofinishing dregs becomes easier. The experimental results show that the supply of current rating is near concern with the position of the negative electrode and the burnishing-tool.
Smooth Processes Simultaneous Module System Design Plane Surface Finish-tool Electrofinishing Burnishing
P.S.Pa
Department of Digital Content Design,Graduate School of Toy and Game Design National Taipei University of Education No.134,Sec. 2,Heping E. Rd.,Taipei City 106,Taiwan
国际会议
常州
英文
409-412
2009-11-19（万方平台首次上网日期，不代表论文的发表时间）