Finite Element Simulation of Ti-6Al-4V Three-dimensional Milling

摘要：

In this paper, by adopting an equivalent geometry model of the cutting layer, a three-dimensional (3D) finite element model was built to investigate the milling of Ti-6Al-4V. The chip separating process was simulated by Arbitrary Lagrangian-Eulerian (ALE) method and automatic re-meshing technology. The experiments of milling Ti-6AI-4V were carried out to verify finite element model of milling process. The comparisons of the predicted cutting forces and the measured forces showed reasonable agreement. Finally, the finite element model was used to predict the chip deformation and the three-dimensional distribution of cutting force, stress and temperature in milling Ti-6Al-4V.

关键词： Finite element Ti-6Al-4V Milling process Simulation

作者: Y.Zhao F.Xu D.W.Zuo J.Kang

作者单位: College of Mechanical and Electrical Engineering,Nanjing University of Aeronautics and Astronautics,Nanjing,210016,China

会议类型: 国际会议

会议名称: The 3rd Conference of Cross-Strait Engineering Education and Ceeusro & 1st International Conference on Engineering Technologies and Ceeusro(ICETC2009)(第三届工程技术与产学研研讨会暨第一届国际功能制造技术学术会议)

会议地点: 常州

会议语种:英文

页码: 701-704

在线出版日期: 2009-11-19（万方平台首次上网日期，不代表论文的发表时间）