Simulation of Cutting Force Based on Software Deform
Using analytic method to analyze the change rule of cutting force fall across hardness, because it relate to non-linear problem that is perplexing. Base on software deform, infection factors were simulated in the process of cutting. The factors cutting include deepness and reamer angle and enter measure. The Simulation get the result that include the influence of the factors and the change rule of cutting force. To The analysis and the simulation of the cuts process through the finite element software that is helpful in optimizes the geometry parameter of the cutting tool and the processing craft parameter choice, exert the efficiency of machine tool farthest. Has saved the cutting tool, the material and laboratory uses experimental expense and so on, reduced the experimental cycle. It has found the new more effective modernized tool for the cutting rule.
DEFORM cutting force finite elemen simulation
WANG Youjun ZHANG Dinghua WU Fujia YAO Kai HOU Zhongming
Northwestern Polytechnical University Xian China North University of China Taiyuan China Xian Architecture Engineering Research Institution Xian China
国际会议
长沙
英文
1176-1179
2009-10-10（万方平台首次上网日期，不代表论文的发表时间）