Study on numerical simulation and experiment of titanium alloy for high speed milling

摘要：

Aim at the difficulty of cutting for titanium alloy, the 3D finite element model has been established The high speed cutting has been simulated using the established model. The chip formation and the cutting force have been analyzed. In the same condition, the cutting experiment has been carried ou. Through the comparison, the result of simulation agrees with the result of experiment well. It proves that the finite element model is correct, and the finite model can be used to investigate the optimization of cutting parameters.

关键词： Titanium alloy Numerical simulation high speed milling finite element model

作者: WU Hong-bing Jia Zhi-xin Zhang Xue-chang LIU Gang

作者单位: School of Mechanical and Energy ,Ningbo Institute of Technology, Zhejiang University,Ningbo 315100, College of Mechanical and Energy Engineering,Zhejiang University,Hangzhou,310027, China

会议类型: 国际会议

会议名称: 2009 Second International Conference on Intelligent Computation Technology and Automation(2009 第二届IEEE智能计算与自动化国际会议 ICICTA 2009)

会议地点: 长沙

会议语种:英文

页码: 1223-1226

在线出版日期: 2009-10-10（万方平台首次上网日期，不代表论文的发表时间）