Influence of the Grain Size on the Microdrawing Formability
Microdrawing is an important process of fabricating the microparts, especially the metal microparts. Under the micro tension test, it was found that the stressstrain curve increased steeply in the elastic deformation stage but gradually in the plastic deformation stage, with the decrease of the grain size. According to the stress-strain curve, the material model was established. Then the influence of the grain size on the drawing formability was simulated by the Abaqus software. The simulation results show that the applied load for microdrawing is decreasing accordingly with the increase of the grain size. Finally, the microdrawing experiment was made to verify the simulation, showing the good agreement between them.
micropart grain size microdrawing size effect
Z.Y. Xu Y. Wang J. P. Wu J. J. Wang G. H. Lu
Mech. Manufacturing, School of Mech. Eng. Xuefu Road 301, diangsu University, Zhenjiang, China, 212013
国际会议
长沙
英文
3517-3520
2009-10-10（万方平台首次上网日期，不代表论文的发表时间）