Study on a Wind-Solar Complementary Power Inverter
This paper studies a wind-solar complementary singlephase sine wave power inverter, including the hardware structure, operating principle, and method to the charging and discharging design. A dual-level three-state intelligent float charging based on PIC single chip control is brought forward for combining the special characteristics of wind-solar energy system. It helps the automatic transfer between charging and discharging and active protection of the battery. Unattended wind-solar complementary power system is achieved. With the help of reasonable calculation and simulation analysis, the final parameters are determined. A prototype of 500W/220V/50Hz single-phase sine wave power inverter has been fabricated. Through the model experiment the output voltage waveforms are found in conformity at both no-load and full-load, and the THD is very low. Therefore, the workability and validity are proved.
wind-solar complementary sine wave pulse width modulation (SPWM) dual levels three states charging total harmonic distortion factor (THD)
Yongjian Li Qingxin Yang Hongxun Liu Jianguo Zhu Youguang Guo Wei Xu
Province-Ministry Joint Key Laboratory of Electromagnetic Field and Electrical Apparatus Reliability Province-Ministry Joint Key Laboratory of Electromagnetic Field and Electrical Apparatus Reliability School of Electrical, Mechanical and Mechatronic Systems University of Technology Sydney Sydney, NSW
国际会议
成都
英文
159-162
2009-09-25（万方平台首次上网日期，不代表论文的发表时间）