Fundamental Research on Electrochemical Micro-machining by Using Water as the Electrolyte

摘要：

The daily-used mineral water is used as the electrolyte for the electrochemical micro-machining (ECMM) in this paper. It is a green, high-precision and low-cost approach for fabricating micro pins. By using the mineral water as the electrolyte has been presented for the first time. The diameter of the machined micro pin can reach around 20 μm with high machining efficiency and repeatability. Moreover, the ECMM hole drilling is investigated to further confirm the machining capability of using mineral water as the electrolyte.

关键词： Electrochemical micromachining Green machining Micro-pin and micro-hole fabrication

作者: Ye Yang Wataru Natsu Wansheng Zhao

作者单位: Department of mechanical systems engineering, Tokyo University of Agriculture and Technology, Tokyo Department of mechanical systems engineering, Tokyo University of Agriculture and Technology, Tokyo State Key Laboratory of Mechanical System and Vibration, School of Mechanical Engineering, Shanghai

会议类型: 国际会议

会议名称: The 16th International Symposium on Electromachining(第16届国际电加工会议)

会议地点: 上海

会议语种:英文

页码: 307-311

在线出版日期: 2010-04-19（万方平台首次上网日期，不代表论文的发表时间）