Effect of Feed Velocity on Cutting Characteristics of Polycarbonate Sheet Subjected to a Two-line Wedge Indentation Ezcited by Ultrasonic Wave
This paper describes a pushing-cut process of a piled-up polycarbonate (PC) sheet. In this work, cutting line force of two-line (facets) blade on a laminated PC sheet was measured with a load cell and its cutting deformation was observed by a CCD camera in order to reveal the effect of feed velocity and ultrasonic excitation of blade on deformation flow of the PC sheet. The profile parameters such as inclined angle, elevation angle and necked height of sheared section were observed with respect to excitation modes of the blade by varying the feed velocity.
Shear Cutting Sticking contact Friction Adhesives Facets
S. Nagasawa T. Takahashi Y. Fukuzawa
Dept. of Mechanical Engineering, Nagaoka University of Technology, 1603-1 Kamitomioka, Nagaoka, Niigata 940-2188, Japan
国际会议
The 16th International Symposium on Electromachining(第16届国际电加工会议)
上海
英文
401-406
2010-04-19（万方平台首次上网日期，不代表论文的发表时间）