Evaluation Tool Condition of Milling Wood on the Basis of Vibration Signal

摘要：

The paper presents preliminary results of the research of tool condition monitoring based on both original and demodulated signals measurements of an vibration generated by a cutting process in milling. The experiments have been performed on the milling center (CNC). Because the dynamic characteristics of tool vibration in machining process will change with tool wear development, which is one of the important dynamic characteristics of tool vibration. The signals were analyzed through FFT analyzer and computer (realised in the environment of NI LabVIEW). Work supported by the Grant 3 P06L 025 24 from Committee of Scientific Research of Poland.

作者: K Szwajka J Gorski

作者单位: Institute of Technology, University of Rzeszow, ul. Rejtana 16A, 35-959 Rzeszow,Poland Faculty of Wood Technology, Warsaw Agriculture University, ul. Nowoursynowska 159,02-776 Warsaw, Pol

会议类型: 国际会议

会议名称: 第四届仪器科学与技术国际会议( 4th International Symposium on Instrumentation and Science and Tcchnology)

会议地点: 哈尔滨

会议语种:英文

页码: 1205-1209

在线出版日期: 2006-08-08（万方平台首次上网日期，不代表论文的发表时间）