Processing, Microstructure and Electromechanical Properties of Pb(Zr, Ti)O3 Fibers Obtained by Thermoplastic Co-Eztrusion

摘要：

Using a torque-rheometer, ceramicpolymer extrudable mixtures were prepared to produce lead zirconate titanate (PZT) fibers through a coextrusion process. A 7.7 mm diameter PZT-polymer rod was coupled with a 24 mm diameter carbon blackpolymer shaped cylinder. This so called preform composite was extruded through a 1 mm die. By this method, 300 μm PZT fiber structures were successfully achieved. The microstructure and the electromechanical properties of these co-extruded sintered fibers were investigated and compared to 300 μm diameter fibers produced by simple thermoplastic extrusion. Although the co-extruded fibers showed similar microstructure properties and only a slightly higher porosity than the extruded ones, the electromechanical performance was noticeably inferior.

作者: M. R. Ismael F. Clemens P. Wyss T. Graule M. J.Hoffmann

作者单位: Empa,Laboratory for High Performance Ceramics,Ueberlandstrasse 129,CH-8600 Duebendorf,Switzerland In Empa,Laboratory for High Performance Ceramics,Ueberlandstrasse 129,CH-8600 Duebendorf,Switzerland Empa,Laboratory for Electronics/Metrology,Ueberlandstrasse 129,CH-8600 Duebendorf,Switzerland Institut für Keramik im Maschinenbau,Universit.t Karlsruhe,Heid-und-Neustr.7,76131 Karlsruhe,Germany

会议类型: 国际会议

会议名称: 2009 The 18th IEEE International Symposium on Applications of Ferroelectrics(2009年国际铁电学暨IEEE国际铁电应用联合会议)

会议地点: 西安

会议语种:英文

页码: 109-112

在线出版日期: 2009-08-23（万方平台首次上网日期，不代表论文的发表时间）