Research on Roundness Error Evaluation of Shaft Parts Based on Genetic Algorithms With Transfer-Operator

摘要：

On the basis of researching definition and measurement method of roundness error of shaft parts,the evaluation model of roundness error based on genetic algorithm with transfer-operator is established. By means of a new idea based on genetiC algorithm with transfer-operator for roundness error which meets the minimum zone method,traditional genetic algorithm was made some suggestions for improvement. The global optimization can theoretically be acquired. The simulation results show that the method is valid at variable global scope,and can correctly evaluate the roundness error of shaft parts.

关键词： genetic algorithm shaft parts roundness error error evaluation.

作者: Li wen Yan Bing Yan Lanrong Cai Guihua Hu Meiting Wang

作者单位: Tianjin Key Laboratory of High Speed Cutting &Precision Machining,Tianjin University of Technology a Tianjin Key Laboratory of High Speed Cutting &Precision Machining,Tianjin University of Technology a College of Mechatronics Engineering and Automation,Shanghai University,200072 Shangha,China

会议类型: 国际会议

会议名称: 2009 9th International Conference on Electronic Measurement & Instruments(第九届电子测量与仪器国际会议 ICEMI2009)

会议地点: 北京

会议语种:英文

页码: 1439-1443

在线出版日期: 2009-08-16（万方平台首次上网日期，不代表论文的发表时间）