Solder Joints Reliability with Different Cu Plating Current Density in Wafer Level Chip Scale Packaging (WLCSP)
Electroplated copper is becoming increasingly important in UBM (under bump metallurgy). The Cu is used as a wetting material for the solder (ball). After reflow the Cu and solder joints are the main contact method for mechanical and electrical interconnection to the pads of the chip. One of the critical factors affecting solder joint reliability is the formation of intermetallic compound (IMC); that is generated at the interface of Cu/solder alloy. The formation of IMC is the merging of the plated copper and solder during the reflow process. The IMC will continue to grow when the structure is subjected to temperature. In this study, different current densitys (0.5ASD, 1.0ASD, 1.5ASD, 2.0 ASD, 2.5ASD, 3.0 ASD) are used on the Cu plating process, which produces different microstructure in the plated Cu layer. It will also impact IMC formation and evolution. The investigation shows that only Cu6Sn5 is generated in as-reflow condition; Cu3Sn is brought forth after being stored at 150 degree C. The early failure was observed at 48hrs, the fracture is located at the interface of Cu and Cu3Sn in ball shear test. The analysis shows that Kirkendall void formation during aging treatment is the key factor for failure.
Kenny Cao KH Tan CM Lai Li Zhang
Jiangyin Changdian Advanced Package CompanyNo. 275, Binjiang middle Road, Jiangyin City Jiangyin Changdian Advanced Package Company No. 275, Binjiang middle Road, Jiangyin City
国际会议
北京
英文
819-823
2009-08-10（万方平台首次上网日期，不代表论文的发表时间）