Finite Element Analysis for Bending Stress of Face-Gear
The top edge of the shaper tooth is rounded to improve the bending strength of face gears, and then the fillet surface equation of face gear is presented. After the Tooth Contact Analysis (TCA), the variation of bending stresses is computed during the cycle of meshing and when some parameters are changed based on the 3-Dimension contact finite element method. Results indicate that both of the nominal pressure angle and shaft adjustments of facegear obviously affect the bending strength.
face-gear stress finite element analysis
Zhang Shuyan Lei Guangming Wang Minghai Guo Hui
School of Science Xian University of Architecture & Technology Xian,710055,China School of Mechatronic Northwestern Polytechnical University Xian,710072,China
国际会议
长沙
英文
1739-1742
2009-04-11（万方平台首次上网日期，不代表论文的发表时间）