The study and realization of standard dynamic signals of dynamic characteristic calibration for high precision displacement sensor
Sine signals and ellipse signals with frequencies (1-100) Hz are selected to calibrate the steady-state response characteristic of the displacement sensors, and impulse signals are selected to calibrate the transient-state response characteristic of the displacement sensors under the condition of non-periodic signal, after analyzing the working states and the frequency response range of the high precision displacement sensors during the actual measurement. These standard dynamic signals can be realized and traced to the length standard by a dynamic characteristic calibration and traceability device for the high precision displacement sensor that developed by NIM. And the dynamic characteristics of the inductance and capacitance sensors are calibrated by using this calibration and traceability device. It can be shown that the amplitude and phase deviations become bigger when the frequency is increased. The sensor accuracy used in the dynamic condition is reduced.
displacement sensor dynamic calibration traceability dynamic response characteristic amplitude and phase analysis
Xue Zi Ye Shu Liang Ye Xiao You
National Institute of Metrology, Beijing, 100013 China Institute of Metrology, Hangzhou, 310018
国际会议
第五届仪器科学与技术国际学术会议(ISIST 2008)Fifth International Symposium on Instrmentation Science and Technology
沈阳
英文
1-6
2008-09-15（万方平台首次上网日期，不代表论文的发表时间）